|
|
|
|
|
"I will have a petticoat of silke,
|
Not visible in the original portrait -
but you may imagine it beneath the forepart and overskirt 
I liked the following description in the wardrobe inventories of Elizabeth I.:
"(...) one Petycoate of crymsen Satten razed [with] a brode border embraudered with silver & frengid lyned with unshorne vellat (...)"
Now - the least thing I wanted to have for this gown was another heavy skirt with
velvet *lining*.
So I decided to just edge the underskirt with velvet rather than completely lining it with that
material. Lucky as I am, I still had some yards of wine red velvet trim, stamped with stylized
flowers and edged with golden braid.
Now - some of you who read the above description might be interested what "razed"
means.
It's much like pinking or slashing, just that the fabric is not completely cut through to reveal
what's beneath it (in this case I would have vaguely understood the lining with velvet!).
'razed' means that the fabric is just cut at the surface, cutting the shining surface warp threads
of the satin but not cutting holes into the fabric. This cut surface is then razed with a knife to
force the cut threads upwards, giving a peach skin like appearance to the satin in those places.
Unfortunately my satin was rather thin, so razing was not really an option as I was
afraid to not only cut the surface threads of the fabric.
Plus I had to piece the petticoat from two different materials - when I had cut the front, back and
two side gores, I didn't have enough material for the last two side gores, which I then cut from a
different, slightly lighter thick habotai silk - these two lighter colored side gores went into the
back sides of the petticoat.
Petticoat shown draped over the farthingale and bumroll, no waistband attached (it's pleated and
attached to the waist with a gathering thread...) and the petticoat is also not hemmed yet,
revealing the lower edge of my blue and white, to long farthingale. The different colored gore can
be seen towards the back on the very right side.
Piecing skirts together is quite period, even from different materials; however,
these materials having obviously different colors is not.
So after sewing the petticoat, I dyed it again in dark red, to make the difference between the two
materials seem less obvious. After that I adjusted the hem length and attached the velvet trim to
it.
Petticoat re-dyed (...but not ironed...), with the velvet trim around the
hem.
Last not least, I laid out the forepart on the
petticoat (while being on my dress mannequin, over the farthingale) and
marked were I would pin it at the bottom of the petticoat with two tiny black spots with a permanent
black marker on both forepart and petticoat.
From my experience, it's enough to attach the top of the forepart with a
band around the waist and pin it to the bottom of the petticoat, this is usually enough to hold it
in place as long as the edges of the forepart are stiff enough.
Petticoat with (undecorated) forepart pinned
on.
As I always attach my foreparts this way, I can now attach whatever forepart I like to my beautiful 'crymsen Satten Petycoate with a vellat border' :-)
Let's move on to the bodice.
| ||||
