Apr 152011
 

This post is also available in: English

Navigation for this part of the page:

 

Here are various tips for dyeing fabrics. I will add more over time.

Dyeing white fabrics ivoryDyeing silk satin

Tip for dyeing white fabrics ivory:

Don’t make the mistake to use a small amount of *yellow* dye. Instead, use a *very* small amount of *olive* dye, even less yellow dye and – depending on if you want a red-based ivory or a green-based ivory – add a little red (or not).

Dilute all the dyes with *lots* of water (and I mean a bucket full or so!) and – after the washing cycle of the machine has started – add that ‚colored water‘ (You should be able to see through it – like tea) to the washing machine.
This mix of dyes will give you a nice warm ivory color, while yellow will result in a more or less strong yellow.

To determine what „a very small amount of dye (powder)“ means, I can tell you how much I used for the machine dye cycle from the olive dye for the forepart and sleeves of the „Maria Di Medici“ gown: not more than I could balance on the tip of a knife; meaning less than a quarter of a teaspoon full. The yellow dye I added was even less, and just a *bit* of red (meaning, but don’t try it that way: no more than could be balanced on the tip of a cigarette).

If I would have discovered – after the dye – that I would need to darken the color a bit, I would have done another dye washing – this time with just a bit of olive and red.
The „bit“ again refers to an amount of dye which could be balanced on the tip of a cigarette (again, don’t try it that way – it’s just difficult to explain amounts of dye powder over an internet site if one doesn’t work with grams while estimating how much is actually needed!).

I could also have tea dyed the fabric, but that was something which came to my mind much later – but tea dye tends to be brownish, which I didn’t want.

The same instructions for diluting the dye with *lots* of water *before* adding it to the washing machine, by the way, also applies for dyeing fabrics in pastel colors.

The problem with silk satin dyeing:

I’ve recently read on a costuming board that some people have problems when dyeing silk satin.

Some say it’s loosing its sheen, others say it gets ugly ‚knots‘ during the washing; the next says that it afterwards has some kinds of ‚folds‘ which will remain in the fabric.

I didn’t want to say anything there, but I’m writing this here:

Hey, folks – have you ever had the idea that there might be *different* silk satins? And, no, I don’t mean the weight – I mean the quality. And that there could be methods not-so-suitable for dyeing silk satin, which can turn even a satin of good quality into a total mess?

I have never ever had any problems when dyeing silk satin. No loss of sheen, no ugly knots. But perhaps that’s because I’m not thinking of treating fabric when I dye it – I’m thinking of treating *hair*. Silk is a protein fiber, like hair, and should not be treated like fabric.

You ask what the difference is?

Well, while you can throw cotton into a boiling bath and rinse it with ice cold water, you shouldn’t even *think* of doing that with silk. Silk needs a *slow* cooling down – a bit of cold water is added to the hot bath, it’s tumbled some times, the machine takes some of the water out, adds some more cold etc. until the water finally *is* completely cold.
The same for washing silk with any detergent you might lay your hands on that doesn’t say it’s *especially* for silk *only* (Germany has a fantastic detergent called Tenestar for silk – I can just warmly recommend it!). In other words: Would *you* wash your hair with usual fabric washing detergent? If not, why not?
And don’t even *think* about tumbling your satin dry!

So how should you dye silk satin?

You should have a washing machine – front loading – which is capable of washing about 5-6 kilograms / 10-12 pounds of fabric. It should have some kind of ‚gentle cycle‘ setting – something between the ‚wool‘ program and the usual washing, which can be set to 60°C. If this gentle cycle can also be used at 95°C – wonderful. The machine should furthermore have some kind of button to add more water (though you can also do this with the help of a bucket after the washing started).

Pre-wash the fabric before dyeing it at about 30° – you might use the wool program of your machine for that. Use the aforementioned silk washing detergent. This is to prevent the satin from getting those strange, non-dyed (or over dyed) ‚folds‘.
Remember, we’re talking about satin, and satin only here – not Duchesse silk, not taffeta, but satin (which, in case you’re in an English speaking country, will usually be sold to you either as ’satin‘ or ‚charmeuse‘, the latter being usually a very thin satin). Taffeta and Duchesse should *not* be washed and / or dyed! They’re woven too tightly and the fibers will break during the washing, resulting in the already mentioned strange ‚pleats‘. (They can be dyed lying flat in a bathtub – but that’s a mess, I can tell you…).
If it already has the ugly knots or loss of sheen after this rather gentle treatment, you can be almost certain that you have some bad quality silk satin.
This needn’t necessarily depend on the dealer who sold you that satin. In fact, not even a whole bolt of silk satin needs to be of bad quality – sometimes it’s the silk of one single worm that’s bad, resulting in one or two yards of bad fabric on that particular bolt.

Afterwards, the dye.
Salt, vinegar (if needed) and the fabric should go into the machine *first*. While the machine adds the water, you can mix your dye colors into a bucket of *cold* water. This will take some minutes (if not, wait) until the machine has added all the water it „thinks“ it needs.
Then *slowly* pour the diluted dye into the washing machine. No more than a glass full per 30 seconds (or so).

If possible, prevent the machine from tumbling the fabric after the last rinse by pressing the appropriate button. If it doesn’t have one and you have the chance – stop the machine before it wants to start tumbling.

*After* the washing and rinse cycles are all finished, you want to wash the fabric with the aforementioned specialized silk detergent. Add about two spoons of vinegar to the last rinse (instead of any fabric softener, which should also *never* be used on silk!). Let the machine tumble your fabric at the lowest possible rate – you want the fabric to get out dripping wet.
Hang it – best in a warm summer night, so it will not see the sun while drying – outside on a possibly straight clothesline.

When it’s dry, iron it from the wrong side. It may be needed to pull the satin while ironing it – this is a very time- and power consuming task, but well worth the effort.

And afterwards you’ll probably be surprised how nicely silk satin can dye, without any loss of sheen or ugly knots…

By the way, I also recommend reading my ‚First sew, then dye‘ tutorial for further elaboration on silk washing methods.

Navigation for this part of the page:

 

 Leave a Reply

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

(erforderlich)

(Pflichtfeld)

Math test (actually, this is spam protection ;-) ): * Time limit is exhausted. Please reload CAPTCHA.